subject
Engineering, 19.10.2019 05:10 tursunovarukhshona

Ch4 and o2 react to form hcho and h2o with a catalyst. the reactants also react to form co2 and h2o under the same conditions. for a basis of 100 mol feed/s and equimolar feed of reactants: i) write the two balanced competing reactions in the reactor; ii). draw and label a flowchart and use a degree-of-freedom analysis based on extents of reaction to determine how many process variables must be specified to calculate the remaining variables; iii). derive expressions for the product stream component flow rates in terms of the extents of the two reactions; iv). calculate the molar composition of the reactor output stream and the selectivity of hcho relative to co2

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
Ch4 and o2 react to form hcho and h2o with a catalyst. the reactants also react to form co2 and h2o...
Questions