subject
Engineering, 19.10.2019 01:00 raivynvieu6605

Annealing is a process by which steel is reheated andthen cooled to make it less brittle. consider the reheatstage for a 100-mm-thick steel plate (7830 kg/m3,c550 j/kgk, k48 w/mk), which is initially at auniform temperature of ti200c and is to be heatedto a minimum temperature of 550c. heating iseffected in a gas-fired furnace, where products of com-bustion at t800c maintain a convection coeffi-cient of h250 w/m2k on both surfaces of the plate. how long should the plate be left in the furnace?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
question
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
You know the right answer?
Annealing is a process by which steel is reheated andthen cooled to make it less brittle. consider t...
Questions
question
Mathematics, 09.02.2021 07:20
question
Mathematics, 09.02.2021 07:20
question
Mathematics, 09.02.2021 07:20