Engineering, 17.10.2019 00:00 achsahjosey

Hydraulic shear
indicate whether the statement is true or false
1. proper eye protection should be used while operating the
hydraulic shear
2. always inspect the machine after starting cutting operations
3. cut flat stock that exceeds 12"if you know what you are doing
4. you should get for cutting long pieces of stock
5. have a partner you on the machine
6. do not cut pipe in the hydraulic shear
7. do not place hands or fingers in the hydraulic shears
8. turn off power if machine overheats
9. clean the machine when you're finished using it
10. leave the machine on when you have completed your project
au awn

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Hydraulic shear
indicate whether the statement is true or false
1. proper eye protection s...

Questions