subject
Engineering, 15.10.2019 21:30 Caixiayang3613

An experimentalist wishes to measure the resistance rs of a sample located down in a cryostat. two wires, each with resistance r = 10ω, carry an ac current i = 1.0 ma down into the cryostat, through the sample, and back up to ground. the voltage across the sample is measured with a differential amplifier. the actual sample resistance is rs = 0.10ω. 1.0ma r 10ω rs 0.10ω r 10ω − + vout (a) what is the differential voltage at the amplifier inputs? (b) what is the common-mode voltage? (c) suppose the amplifier is similar to the one you will build in lab, with gdiff = 10 and gcm = 0.50. what is the amplitude of the ac signal at vout? (d) if the experimenter assumed that her amplifier was ideal, with gdiff = 10 but gcm = 0, what would she report for the value of rs? (e) what is the minimum cmrr (= gdiff/gcm) her amplifier would need in order to measure rs to an accuracy of 1%?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
You know the right answer?
An experimentalist wishes to measure the resistance rs of a sample located down in a cryostat. two w...
Questions
question
History, 18.09.2019 18:30