Engineering, 14.10.2019 21:00 OlamideO3

To defog the rear window of a bmw automobile, a very thin transparent heating element is attached to the inner surface of the window. a uniform heat flux of 1400 w/m2 is provided to the heating element for defogging a rear window with thickness of 5 mm. the interior temperature of the bmw is 23°c and the convection heat transfer coefficient is 18 w/m2 .°c. the outside ambient temperature is -9°c and the convection heat transfer coefficient is 110 w/m2 .°c. if the thermal conductivity of the window is 1.4 w/m.°c, determine the inner surface temperature of the window. (30 points)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

To defog the rear window of a bmw automobile, a very thin transparent heating element is attached to...

Questions