Engineering, 11.10.2019 04:10 zoieihazel

You are interning at a power-plant engineering company that is in the process of designing a new steam cycle. your manager asks you to in estimating the turbine work output for 2 different operating conditions: (i) water enters the turbine at 600 °c and 17.5 mpa and exits at 20 kpa as a saturated mixture with a quality of 0.95. (ii) same inlet conditions as (i), but exits at 20 kpa as a saturated mixture with a quality of 0.85. (a) calculate the turbine work output per unit mass of water for conditions (i) and (ii). (b) comment on the difference in the turbine work output between conditions (i) and (ii). (c) show the process across the turbine for conditions (i) and (ii) on the same t–v diagram.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

You know the right answer?

You are interning at a power-plant engineering company that is in the process of designing a new ste...

Questions