Engineering, 10.10.2019 03:30 eila3601

From experiments performed in water at 1.00 atm, 25°c, with ca0 = c b0 = 2.0 m, the rate is found to vary with fractional molar conversion of a (f_a) according to: 1/(-r(f_a ) )=0.33-1.27f_a-5.37f_a^2 [=] (l•hr)/mol calculate the time (hr) required to obtain 0.60 fractional molar conversion in a batch reactor containing 1,000 l of solution in which the initial concentration of each species is 2.0 m, and p and t are held constant at 1.0 atm and 25°c, respectively. calculate the volumetric flow rate (l/hr) of a stream containing 2.0 m of each reactant that is converted using a 1,000 l pfr to a fraction molar conversion of 0.60. calculate the volumetric flow rate (l/hr) of a stream containing 2.0 m of each reactant that is converted using a 1,000 l cstr to a fractional molar conversion of 0.60.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

From experiments performed in water at 1.00 atm, 25°c, with ca0 = c b0 = 2.0 m, the rate is found to...

Questions