Engineering, 10.10.2019 00:00 SmokeyRN

1. hydraulic shears are used in manufacturing are used to cut large sheets of metal. using hydraulic pressure, the machine pushes a wedge to cut the metal. the wedge has a 0.25 inch thick cutting blade and the length of the blade is 5 inches. hydraulic pressure applies an effort of 2000 ib to the wedge. what's the ideal mechanical advantage to the wedge?

2. how much resistance force can ideally be generated by the 2000 ib efforct force?

3. a wheelchair ramp has a height of 4 feet. the base of the ramp measures 11 feet. what is the slope of the ramp?

4. what is the idea mechanial advantage is the ramp?

5. if a person and a wheelchair have a combined weight of 150 ib, how much effort force is required to travel up the ramp?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

You know the right answer?

1. hydraulic shears are used in manufacturing are used to cut large sheets of metal. using hydraulic...

Questions