Engineering, 10.10.2019 00:00 StupidFatChipmunk

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2. an industrial water shutoff valve is designed to operate with 15 ib of effort force. the valve will encounter 155 ib of resistance force applied to a 0.85 in diameter axle. what is the actual mechanial advantage of the sytem?

3. if the diameter of the wheel is 10.5 inches, what is the efficiency of the wheel and axle system?

4. a block and tackle system with 8 supporting strands is used to lift materials in a manufacturing facility. the motor being used to wind the cable in the pulley system can provide 200 ib of force. what is the ideal mechanical advantage of the pulley system?

5. ideally what is the maximum weight of materials that can be lifted?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

You know the right answer?

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2....

Questions