Engineering, 07.10.2019 22:20 chrismeldajbaptiste

Need asap
1. name the view that shows the width (height) of the coupling.

2. name the view in which the holes are shown as circles.

3. name the kind of line shown at e, f, g, h, i, and j.

4. what circle represents the 4.500 diameter flange?

5. what circle represents the 1. diameter?

6. name the kind of line shown at n.

7. how many holes are to be drilled in the larger flange?

8. indicate the drill size to be used.

9. give the diameter circle on which the equally spaced holes are drilled in the larger flange

10. how many holes are to be drilled in the smaller flange?

11. how deep is the 1.250 diameter hole?

12. give the diameter of the reamed holes.

13. state the angle with the horizontal center line used for locating reamed hole o.

14. what is the overall width (height) of the coupling?

15. what is the diameter of the smaller flange?

16. what is the diameter of the circle a and b?

17. what is the depth of the 1.000" hole?

18. what is the thickness of the larger flange?

19. if 5/16" bolts are used in the 7 drilled holes, what will be the clearance between the hole and the bolt?

20. determine distances c and d.

Need asap1. name the view that shows the width (height) of the coupling.2.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

Need asap
1. name the view that shows the width (height) of the coupling.

2. name t...

Questions