Engineering, 05.10.2019 05:20 pencil8184

An aluminum alloy [e = 73 gpa] cylinder (2) is held snugly between a rigid plate and a foundation by two steel bolts (1) [e = 180 gpa]. the aluminum cylinder has a length of l2 = 275 mm and a cross-sectional area of 2300 mm2. each steel bolt has a length of l1 = 335 mm and a diameter of d1 = 14 mm. the bolt has a pitch of 1 mm. this means that each time the nut is turned one complete revolution, the nut advances 1 mm. the nut is hand-tightened on the bolt until all slack has been removed from the assembly but no stress has yet been induced. determine the magnitude of the normal stress produced in the aluminum cylinder when the nut is tightened one complete turn past the snug-tight condition.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

An aluminum alloy [e = 73 gpa] cylinder (2) is held snugly between a rigid plate and a foundation by...

Questions