subject
Engineering, 05.10.2019 12:00 lol15arec001

Which of the following statements about electronic ignition modules is correct?
a. electronic ignition modules are easily damaged by moisture, oil, and dirt.
b. most electronic ignition modules have long life spans and don't require any adjustments.
c. electronic ignition modules are very expensive, so they're usually repaired rather than replaced.
d. because electronic ignition modules contain so many moving parts, they tend to wear out very quickly.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Which of the following statements about electronic ignition modules is correct?
a. electronic...
Questions
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Social Studies, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
English, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
English, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Health, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Spanish, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Social Studies, 15.09.2020 01:01
question
Health, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01
question
Mathematics, 15.09.2020 01:01