Engineering, 05.10.2019 12:00 simonthang8
Explain the importance of time in the testing of polymers
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
You know the right answer?
Explain the importance of time in the testing of polymers...
Questions
Mathematics, 05.01.2021 08:00
English, 05.01.2021 08:00
English, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
Computers and Technology, 05.01.2021 08:00
History, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
History, 05.01.2021 08:00
SAT, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
Chemistry, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
Mathematics, 05.01.2021 08:00
