Engineering, 02.10.2019 04:30 alexvillaa121

1) a crew of 5 carpenters and 2 laborers will be used to build formwork for a concrete structure. work is scheduled for 10 hr. /day on monday through friday and 8 hr. on saturday. overtime at a rate of one and one-half will be paid for all hours over 8 hr. /day on monday through friday and double-time for all saturday work. the base wage, taxes, and insurance rates are given below. calculate the hourly, weekly, and monthly cost for the crew.

items carpenters laborers
base wages 21.78/haur 15.56/hour
worker compensation 19.34/100 16.23/100 base wages
public liability 4.29/100 3.57/100 base wages
social security 7.65% 7.65%state unemployement 3.0% 3.0%fringe benefit 3.75/hr 2.8/hr

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

1) a crew of 5 carpenters and 2 laborers will be used to build formwork for a concrete structure. wo...

Questions