Engineering, 01.10.2019 02:20 batmannn1516

Two pipes with length, thickness and outer diameter of 4-m, 0.4-cm and 10 cm, respectively, are used for transporting superheated vapor in a manufacturing plant. the pipes with thermal conductivity of 55 w/m. k are connected to each other through two 1- cm-thick flanges of outer diameter 19 cm. the superheated vapor flows inside the pipe at an average temperature of 483 k with a heat transfer coefficient of 180 w/m2 .k. air condition surrounding the pipes has a temperature of 283 k and a convection heat transfer coefficient of 25 w/m2 .k. (a) determine the average outer surface temperature of the pipe, disregarding the flanges. (b) considering the flanges as the fins and using this temperature for the base of the flange, determine the fin efficiency and the rate of heat transfer from the flanges. (40 points)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

You know the right answer?

Two pipes with length, thickness and outer diameter of 4-m, 0.4-cm and 10 cm, respectively, are used...

Questions