subject
Engineering, 01.10.2019 01:20 maria7515

A200 mw combined cycle gas turbine (ccgt) power generation station is considering the addition of a carbon capture and storage (ccs) system. the power generation station has a capacity factor of 90% and a heat rate of 8530 btu/kwh (higher heating value). the ccs system will remove and stores 85% of the co2 produced by the power generation station. however, the ccs system will reduce the efficiency of the plant by 6%. for example a plant with 32% efficiency without a ccs system would have 26% efficiency with a ccs system. the rated capacity of the plant will remain at 200 mw after the installation of the ccs. assume the natural gas used to fuel the ccgt power generation station is composed of 95% methane (ch4) and 5% nitrogen (n2) on a volumetric basis and has a higher heating value of 52.8 mj/kg. it is purchased for $3.50/mbtu. a. what is the mass fraction of carbon (c) in the natural gas (kg/kgna)? b. what is the co2 emission factor for the natural gas fuel (kgco2/mbtung)? c. what are the co2 emissions per mwh of electricity delivered for the current power generation station (mgco2/mwh)? d. what are the annual co2 emissions of the current generating station (mgcoz/y)? e. what would be the co2 emissions per mwh of electricity delivered if the ccs were installed (mgco2/mwh)? f. what would be the annual co2 emissions if the ccs is installed (mgooz/y)? g. how many metric tons of co2 emissions would be avoided annually if the ccs is installed (mg0oz/y)? h. what is the increased cost of fuel per year of electricity generated as a result of the ccs system (106 $/y)? i. what is the increased cost of fuel per metric ton of co2 avoided ($/mg002)?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20Β°c. air approaches the tube bank in the normal direction at 0Β°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5Β°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
A200 mw combined cycle gas turbine (ccgt) power generation station is considering the addition of a...
Questions
question
Social Studies, 15.07.2019 03:50