Engineering, 30.09.2019 20:30 yairreyes01

Agas stream contains 18.0 mole% hexane and the remainder nitrogen. the stream flows to a condenser, where its temperature is reduced and some of the hexane is liquefied. the hexane mole fraction in the gas stream leaving the condenser is 0.0500. liquid hexane condensate is recovered at a rate of 1.50 l/min. n2 c6h14(v) (5.00 mole%) n2 c6h14(v) (18.0 mole%) liquid condensate 1.50 l c6h14 (l)/min condenser (a) what is the flow rate of the gas stream leaving the condenser in mol/min? (hint: first calculate the molar flow rate of the condensate and note that the rates at which c6h14 and n2 enter the unit must equal the total rates at which they leave in the two exit streams.) (b) what percentage of the hexane entering the condenser is recovered as a liquid? (c) suggest a change you could make in the process operating conditions to increase the percentage recovery of hexane. what would be the downside?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

You know the right answer?

Agas stream contains 18.0 mole% hexane and the remainder nitrogen. the stream flows to a condenser,...

Questions