subject
Engineering, 26.09.2019 17:20 Kaiyla44

When initially bringing a vehicle into a service bay, why should
you leave the engine running when you first exit the vehicle?
o a) in order to verify that the hood release is functional
o b) in order to check the engine oil while the engine is running
c) to check the power steering fluid with the engine running
o d) to check the automatic transmission fluid with the engine running

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
question
Engineering, 06.07.2019 03:10
An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.
Answers: 1
You know the right answer?
When initially bringing a vehicle into a service bay, why should
you leave the engine running...
Questions
question
Mathematics, 25.05.2021 15:30
question
Mathematics, 25.05.2021 15:30