Engineering, 25.09.2019 01:20 pookie1971

If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well insulated. a special, thin coating is applied to the top surface such that it absorbs 80% of any incident solar radiation, while having an emissivity of 0.25. the density p and specific heat c of aluminum are known to be 2700 kg/m3 and 900 j/kg k, respectively. (a) consider conditions for which the plate is at a temperature of 25 c and its top surface is suddenly exposed to ambient air at t=20 c and to solar radiation that provides an incident flux of 900 w/m2 . the convection heat transfer coefficient between the surface and the air is h = 20 w/m^2 k. what is the initial rate of change of the plate temperature?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

You know the right answer?

If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well...

Questions