Engineering, 23.09.2019 17:30 droidd133

You give tours on the great lakes and talk about points of interest. a lighthouse typically has 2 beacons that rotate together—but not necessarily facing opposite directions. in that way, it can be a shorter time between the first and second flashes than between the second flash and the third flash (when the first beacon comes around for the second time). one way of identifying which lighthouse you are looking at is to find the ratio of the short time between flashes to the long time between flashes. if the beacons are set 120° apart along the rotation, as shown below, what is this ratio?
a diagram of a lighthouse beacon. the lighthouse is circular. beacon 1 and 2 are 120 degrees apart.
1: 120
120: 1
1: 3
3: 1
1: 2

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

You give tours on the great lakes and talk about points of interest. a lighthouse typically has 2 be...

Questions