Engineering, 18.09.2019 20:30 tokuichi3135
The extrusion die for a polyethylene parison used in blow molding has a mean diameter of 20.0 mm. the size of the ring opening in the die 2.0 mm. the mean diameter of the parison is observed to swell to a size of 23.0 mm after exiting the die orifice. if the diameter of the blow-molded container = 125 mm, determine: (a) the corresponding wall thickness of the final container, (b) the inside diameter of the parison.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
You know the right answer?
The extrusion die for a polyethylene parison used in blow molding has a mean diameter of 20.0 mm. th...
Questions
Computers and Technology, 05.08.2020 17:01
Biology, 05.08.2020 17:01
