subject
Engineering, 14.09.2019 01:30 kamand10

Acompressor blade design tested in a cascade is found to choke with an inlet mach number of 0.9 when the inlet flow angle is 52 deg. if the ratio of the throat area to the frontal area, a*/h1s, for the cascade is).625, calculate the loss of stagnation pressure between the far upstream and the throat and express this as a loss coefficient. give your comments on what could cause this loss.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 19:20
The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal
Answers: 3
You know the right answer?
Acompressor blade design tested in a cascade is found to choke with an inlet mach number of 0.9 when...
Questions
question
Mathematics, 02.10.2019 23:30