Engineering, 14.09.2019 01:20 okstyles

Calculate the steady-state temperature for a metal roof and comment on whether a cat would be able to comfortably walk across the roof. the roof initially has a uniform solar heat flux of g = 750 w/m2 and has emissivity of 0.13 and solar absorptivity of 0.65. the large surrounding sky is at an effective temperature of 275 k. air over the roof is not moving much and provides a convective heat transfer coefficient of 7 w/m2k and the air temperature is 16oc. assume that the lower side of the roof is well insulated. a) make a sketch of the roof and use arrows and labels to show the heat transfer to and from the roof. b) calculate the temperature of the roof for the case described in the problem statement. c) during the solar eclipse for louisville, the coverage of the sun was 96%. calculate the steady-state (even though the maximum eclipse only lasted a few minutes, we are going to assume a steady-state condition) temperature of the roof during the solar eclipse.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

You know the right answer?

Calculate the steady-state temperature for a metal roof and comment on whether a cat would be able t...

Questions