subject
Engineering, 13.09.2019 23:30 AngelOfLove

The compound wooden beam is connected together by at bolt at b. assuming that the connections at a, b, c. and d exert only vertical forces on the beam, determine the required diameter of the bolt at b and the required outer diameter of its washers if the allowable tensile stress for the bolt is (sigma t)allow = 150 mpa and the allowable bearing stress for the wood is (sigma b)allow = 28mpa. assume that the hole in the washers has the same diameter as the bolt.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
The compound wooden beam is connected together by at bolt at b. assuming that the connections at a,...
Questions
question
Mathematics, 01.11.2019 16:31
question
Mathematics, 01.11.2019 16:31