Engineering, 13.09.2019 16:30 hannahkharel2

You are asked to design a pump station to conveywaste water at a
flow rate of 250 cubic meters per hour to anequalization tank. a
velocity of at least 3ft/s must be maintainedin the pipe to prevent
deposition and provide scouring of anypreviously deposited solids.
however, a maximum velocity of 10ft/sis prescribed to prevent
oversizing the pumps. due to the nature ofthe waste water, you want
to target the high end of this range. find the proper diameter pipe
to the nearest 2" to achieve thisdesign objective.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

You know the right answer?

You are asked to design a pump station to conveywaste water at a
flow rate of 250 cubic meters...

Questions