Engineering, 10.09.2019 21:30 mbonham481

Atransparent film is to be bonded onto the top surface of a solid plate inside a heated chamber. for the bond to cure properly, a temperature of 70c is to be maintained at the bond, between the film and the solid plate. the transparent film has a thickness of 1mm and thermal conductivity of 0.05w/mk, while the solid plate is 13mm thick and has a thermal conductivity of 1.2w/mk. inside the heated chamber, the convection heat transfer coefficient is 70w/m^2k. if the bottom surface of the plate is maintained at 52c, determine the temperature inside the heated chamber and the surface temperature of the transparent film. assume thermal contact resistance is negligible. answers: 127c, 103c
(hint: this is a one-dimensional, steady-state, heat conduction problem. the answers above are correct, i just need to see how to solve this problem)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

Answer

You know the right answer?

Atransparent film is to be bonded onto the top surface of a solid plate inside a heated chamber. for...

Questions