Engineering, 10.09.2019 20:30 smolemily

For each of the descriptions below perform the following tasks:
(1) identify the degree and cardinalities of the relationship (2) express the realtionships in each description graphically with an e-r diagram
(a) a book is identified by its isbn number and it has a title, a price, and a date of publication. it is published by a publisher which has its own id number and a name. each book has exactly one publisher but one publisher typically publishes multiple books over time.
(b) a book (see 2a) is written by one or multiple authors. each author is identified by an author number and has a name and date of birth. each author has either one or multiple books; in addition, occasionally data are needed regarding prospective authors who have not yet published any books.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

For each of the descriptions below perform the following tasks:
(1) identify the degree and c...

Questions