In a piece of aluminum you want to make a pocket (milling of cavities), an end mill tool of 6 mm in diameter and 4 cutting sides will be used, the height of the cutting sides of the tool is 25 mm. the feed that will be taken per tooth will be 0.3 meters / tooth, and a linear feed rate of 2.4 mm / second. calculate the cutting speed in mts / min.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um