Engineering, 30.08.2019 02:10 FAKE5979

In a piece of aluminum, a 15 mm wide groove with a length of 1.5 m and a cutting depth of 5 mm must be made, due to the characteristics of the material it is recommended to have an advance of 250 mm / min, and a cutting speed of 45 m / min. if roughing is done with a 15 mm diameter end mill tool, calculate the following: a)- the rpm necessary to have a good finish, b) -the cycle time in seconds to perform the machining. c)- the volume of chips removed per minute.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

In a piece of aluminum, a 15 mm wide groove with a length of 1.5 m and a cutting depth of 5 mm must...

Questions