Engineering, 23.08.2019 19:20 genyjoannerubiera
You are investigating a 5 cm diameter part that will operate under a 0.75 mn load in service. the material has a yield strength of 450 mpa, a uts of 600 mpa, and fracture toughness 75 mpa m 2 a. will the part fail in ductile yield? b. will the part fail by necking and rupture? c. what is the critical flaw size necessary for fast fracture to occur?
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
You are investigating a 5 cm diameter part that will operate under a 0.75 mn load in service. the ma...
Mathematics, 14.07.2020 22:01
English, 14.07.2020 22:01
Mathematics, 14.07.2020 22:01
Mathematics, 14.07.2020 22:01
Mathematics, 14.07.2020 22:01
Advanced Placement (AP), 14.07.2020 22:01
Mathematics, 14.07.2020 22:01