subject
Engineering, 22.08.2019 16:20 saucyyyyniahhhhh

Consider a power plant of 400 mw e burning coal with a hhv of 30,200 kj/kg and sulfurcontent of 2% by mass. assume the power plant efficiency of 40% and heat capacity ofwater is 4.18 kj/kgk. a) determine the rate of fuel (coal) consumption in kg/s. b) limestone (caco3) is used to capture so2. the chemical reaction is given below. determinethe amount of limestone (caco 3 ) required per hr. caco3 + so2 + 0.5o2 β†’ caso4 + co2

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
You know the right answer?
Consider a power plant of 400 mw e burning coal with a hhv of 30,200 kj/kg and sulfurcontent of 2% b...
Questions
question
Mathematics, 27.08.2020 17:01
question
Mathematics, 27.08.2020 17:01
question
Biology, 27.08.2020 17:01