subject
Engineering, 22.08.2019 05:30 nadarius2017

Aflat plate maintained at a temperature of 80°c experiences a flow of atmospheric air at 0°c. if the temperature gradient at the plate's surface at a given downstream-stream location is 43°c/mm, what is the local heat transfer coefficient?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
You know the right answer?
Aflat plate maintained at a temperature of 80°c experiences a flow of atmospheric air at 0°c. if the...
Questions
question
Mathematics, 26.01.2021 14:00
question
History, 26.01.2021 14:00
question
Mathematics, 26.01.2021 14:00
question
Spanish, 26.01.2021 14:00