subject
Engineering, 20.08.2019 21:30 ValeryGi3721

Sae 30 oil at 20°c flows between two horizontal 0.50-m-wide parallel plates sepa- rated by 30 mm. the length of the top and bottom plates in the direction of flow is 2 m, the bottom plate is stationary, the top plate moves at 3 cm/s, an adverse pressure gradient of 700 pa/m is applied between the plates, and the flow is laminar between the plates. determine the flow rate between the plates and the force that must be applied to move the top plate.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Sae 30 oil at 20°c flows between two horizontal 0.50-m-wide parallel plates sepa- rated by 30 mm. th...
Questions
question
Social Studies, 01.12.2020 01:00
question
Mathematics, 01.12.2020 01:00
question
History, 01.12.2020 01:00
question
English, 01.12.2020 01:00
question
Mathematics, 01.12.2020 01:00