Engineering, 20.08.2019 21:10 davestrider404
Room temperature air flows over a horizontal smooth flat plate at a freestream speed of u = 20 m/s. the plate length is l = 1.5 m and its width is b = 0.8 m. the boundary layer is tripped at its leading edge so that it is turbulent over its entire length. using results based on the 1/7th power velocity profile, evaluate the boundary layer thickness δ at the trailing edge of the plate. calculate the wall shear stress at the trailing edge of the plate. estimate the drag (due to friction) on the portion of the plate between x = 1.0 m and the trailing edge and compare this with the drag over the first 0.5 m of the plate.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
Engineering, 04.07.2019 19:20
Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.
Answers: 1
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
Room temperature air flows over a horizontal smooth flat plate at a freestream speed of u = 20 m/s....
Questions
