Engineering, 20.08.2019 17:20 abbeygrace13

Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the high pressure turbine at 80 bar, 560°c with a mass flow rate of 2x10 kg/hr. the flow rate of 2x100kg/hr. the steam exits the high pressure turbine at 5 bar, 180°c where the steam is then sent back where the steam is then sent back to the boiler and reheated to 480°c before expanding through the low pressure turbine to cooling water enters the condenser from a lake at 20°c and exits at 32°c. assume the low pressure turbine has an isentropic efficiency of 92% and that the pumps opera isentropically. draw a t-s diagram of this cycle and determine the following: high pressure turbine isentropic efficiency net power output, mw low pressure turbine exit quality cycle thermal efficiency the mass flow rate of the cooling water from the lake

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

You know the right answer?

Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the...

Questions