Engineering, 20.08.2019 17:20 christopherwilde

A550 mm outer diameter by 350mm inner diameter cast iron hub with 100gpa modulus of elasticity and 300mm in length is to have a shrink fit with a 350mm outer diameter by 250mm inner diameter steel shaft with 200gpa modulus of elasticity. the maximum tangential stress is to be 100mpa. given that the coefficient of friction is to be 0.15, the to be 0.30 and cast iron is to be 0.2. determine: i) the maximum interference ii) the axial force required to fit the hub on to the shaft iii) the torque transmitted by the shaft

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

A550 mm outer diameter by 350mm inner diameter cast iron hub with 100gpa modulus of elasticity and 3...

Questions