Engineering, 07.08.2019 19:30 risarod6106

Air enters a compressor at a state of 100kpa and 17°c and exits at a final state of 600kpa and s a. sketch the system in question identifying the system boundary and the energy flows. b. determine the entropy change of the air through the compressor assuming constant specific heats. c. is entropy increasing or decreasing within this system? why? d. sketch a t-s diagram of the process and label the process 1-2. e. now determine the entropy change of the air through the compressor assuming the specific heats vary. f. under what condition would the two values that you calculated for entropy change (constant specific heats and varying constant specific heats) be drastically different from each other?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

Air enters a compressor at a state of 100kpa and 17°c and exits at a final state of 600kpa and s a....

Questions