subject
Engineering, 07.08.2019 19:10 scasemere

Specify a parallel key for a gear to be mounted on a shaft with a 2.00 in diameter. the gear transmits 21000 lb. in of torque and has a hub length of 4.00 in. use sae 1035 steel for the key and assume that the key material is weakest when compared with the shaft and hub materials. if sae 1035 steel is not suitable you can use stronger steel by specifying it.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
question
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
You know the right answer?
Specify a parallel key for a gear to be mounted on a shaft with a 2.00 in diameter. the gear transmi...
Questions
question
Mathematics, 09.02.2021 19:10
question
English, 09.02.2021 19:10
question
Mathematics, 09.02.2021 19:10