Engineering, 03.08.2019 03:30 driskell3

Water is the working fluid in a rankine cycle. steam enters the turbine at 1400 lbf/in.2 and 1000°f. the condenser pressure is 2 lbf/in.2 both the turbine and pump have isentropic efficiencies of 85%. the working fluid has negligible pressure drop in passing through the steam generator. the net power output of the cycle is 1 × 109 btu/h. cooling water experiences a temperature increase from 60°f to 76°f, with negligible pressure drop, as it passes through the condenser. determine for the cycle (a) the mass flow rate of steam, in lb/h. (b) the rate of heat transfer, in btu/h, to the working fluid passing through the steam generator. (c) the thermal efficiency. (d) the mass flow rate of cooling water, in lb/h.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

You know the right answer?

Water is the working fluid in a rankine cycle. steam enters the turbine at 1400 lbf/in.2 and 1000°f....

Questions