Engineering, 01.08.2019 00:30 devnnn44

What do you believe is the most important aspect or criteria for developing and validating an effective response plan? why do you see this as the most important aspect? is there any literature to support your response? provide the reference or citationthat supports your position. the criteria for developing and validating an effective response plan includes seven (6) steps as outlined below:
1. acceptability - the plan must anticipate scenarios which are consistent with applicable laws.
2. adequacy – the plan must comply with all applicable planning guidance from fema, homeland security, etc.
3. completeness – the plan must incorporate major actions, objectives and tasks.
4. consistency and standardization of products – the plan must be consistent with all other related documents.
5. feasibility – the plan must include feasible tasks to be accomplished with the resources that are available.
6. flexibility – the plan must be flexible enough to include accommodate all hazards and contingency plan.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

What do you believe is the most important aspect or criteria for developing and validating an effect...

Questions