subject
Engineering, 26.07.2019 17:10 tapiamelissa6

In a refinery, hot flue gasses at 1800°c are cooled by a fluid at 25°c with the gas and liquid side heat transfer coefficients being 50 and 500 w/m2-k, respectively. the wall that separates the gas and liquid side is composed of stainless steel and has a thickness 1cm. assuming no contact resistances, determine: a)- the rate of heat losses per unit area from the gas to the liquid. b)- will the wall melt on the gas side? the solidus temperature of the stainless steel is 1400°c data for stainless steel: k-25 w/m. k

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
In a refinery, hot flue gasses at 1800°c are cooled by a fluid at 25°c with the gas and liquid side...
Questions
question
Mathematics, 03.03.2021 04:20
question
Mathematics, 03.03.2021 04:20
question
World Languages, 03.03.2021 04:20
question
Mathematics, 03.03.2021 04:20