subject
Engineering, 17.07.2019 21:30 anggar20

Aparticle of mass 1kg rests on the surface of a rough plane inclined at an angle 30° to the horizontal. it is connected by a light inelastic string passing over a smooth pulley at the top of the plane to a particle of mass 5kg which is hanging freely. the coefficient of friction between the 1kg mass and the plane is %. the system is released from rest when the 5kg mass is at the height of 2m above the ground. in subsequent motion the 5kg mass hits the ground and does not rebound. before the 5kg mass hits the ground find the acceleration of the system when it is released from rest calculate the tension in the string. find also the force exerted by the string on the pulley. when the 5kg mass hits the ground determine the velocity of the two particles. after the 5kg mass hits the ground; the greatest distance travelled by the lkg mass if the pulley is of such height that the lkg mass never reaches the pulley.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
Aparticle of mass 1kg rests on the surface of a rough plane inclined at an angle 30° to the horizont...
Questions
question
Mathematics, 30.01.2021 04:20
question
Chemistry, 30.01.2021 04:20
question
Mathematics, 30.01.2021 04:20
question
Biology, 30.01.2021 04:20
question
Mathematics, 30.01.2021 04:20