Engineering, 11.07.2019 04:30 1hannacarson

Water enters a thin wall tube with length l = 5 m and diameter d = 0.25 inch. the internal roughness of the tube surface is e = 15 micrometers. a uniform heat flux of 45.1 kw/m2 is applied to the surface of the tube. the flow rate of the water is 0.5 gal/min and the inlet temperature is t = 10°c. the tube exits to atmospheric pressure. a.) determine the mean temperature of the flow leaving the tube. b.) determine the pressure at the inlet to the tube. c.) determine the surface temperature of the tube at the exit. d.) how long can the tube be before you will see local boiling at the surface of the tube at the exit?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

Water enters a thin wall tube with length l = 5 m and diameter d = 0.25 inch. the internal roughness...

Questions