subject
Engineering, 11.07.2019 03:10 sonnyboi2305

An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure difference between the pressure tapping points is 35 kn/m2. the flow rate of water through the meter is obtained by measuring the times required to collect a certain quantity of water in a tank and such measurements gave an average quantity of 580 litres of water collected in 2 min. determine the coefficient of discharge of the meter.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
An orificemeter has a diameter of 75 mm at the entrance and 35 mm diameter orifice. the pressure dif...
Questions
question
Mathematics, 03.10.2019 06:00
question
Mathematics, 03.10.2019 06:00
question
History, 03.10.2019 06:00