Engineering, 11.07.2019 01:10 ljohnson135
The yield stress of a tension specimen machined from a 2-m wide by 0.6-cm thick copper sheet is 145 mpa. the sheet is rolled further with an applied tensile force in the plane of the sheet of 0.22 mn. what roll pressure is needed to just cause yielding? you may ignore friction between the metal and the rolls. for rolling, the deformation occurs by plane-strain in which there is no increase in the width of the sheet. you may also assume that for plastic flow the poisson's ratio v 0.5, and the copper obeys von mises criterion
Answers: 3
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
The yield stress of a tension specimen machined from a 2-m wide by 0.6-cm thick copper sheet is 145...
Social Studies, 05.05.2020 17:24
Mathematics, 05.05.2020 17:24
History, 05.05.2020 17:24
Business, 05.05.2020 17:24
English, 05.05.2020 17:24