Engineering, 11.07.2019 01:10 ayri9893

The poppet of the pressure relief valve must move 0.2 in from the fully closed position in order to pass the full pump flow at the prv setting (full pump flow pressure). the poppet has a 0.85 in3 area on which system pressure acts. assuming that the relief valve cracking pressure should be 15% higher than the pressure required to overcome the hydraulic cylinder punching operation, find the required a) spring constant of the compression spring in the prv, b) initial compression of the spring from its free-length condition as set by the spring-adjustment mechanism of the prv (poppet held against its seat by spring).

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

Answer

You know the right answer?

The poppet of the pressure relief valve must move 0.2 in from the fully closed position in order to...

Questions