Engineering, 11.07.2019 01:10 Adithya27
The boeing 747 is an air plane often equipped with four pratt and whitney jt9d engines that can each offer 193.50 kn of thrust. the air plane has a cruise speed of 907 km/hour, and typical cruise altitudes are of 11 km where the air temperature is -56 °c and density is 0.36 kg/m^3. its coefficient of drag at cruise conditions is 0.031, using the total wing area of 511m^2 as the reference area. its maximum take-off mass is 333000 kg a) what is the plane's coefficient of lift during cruise at its maximum take-off mass? b) what percentage of maximum thrust is required to keep the plane cruising? c) what is the plane's maximum angle of ascent? use the coefficient of lift calculated in part a). the following may be of : a cos(x) + bsin(x) = r cos(x-a) where r = va2+52 and a = tan(b/a)
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
The boeing 747 is an air plane often equipped with four pratt and whitney jt9d engines that can each...
Questions
Health, 02.11.2020 17:20
Mathematics, 02.11.2020 17:20
Mathematics, 02.11.2020 17:20
Mathematics, 02.11.2020 17:20
Mathematics, 02.11.2020 17:20
Spanish, 02.11.2020 17:20
World Languages, 02.11.2020 17:20
