subject
Engineering, 24.10.2019 16:43 tlily2480

Apiston-cylinder assembly contains 0.15 kg of air at a temperature of 350°c and a pressure of 2 mpa, undergoes three reversible processes in series process 1-2: the air is expanded isothermally until the pressure is 500 kpa process 2-3: the air is compressed polytropically with a polytropic index of 1.2 back to 2mpa. process 3-1: the air is compressed at constant pressure to the initial state given for air: r = 0.287 kj/kgk. a)- sketch the processes on a p-v diagram. b. i)- the volume of air in the system at the initial state and at the end of each process. ii)- the boundary work at the end of each process. (0.0134 m3, 0.0536 m3, 0.0169 m3, w2- 37.15 kj, 2w3--35 kj, 3w17 kj)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Apiston-cylinder assembly contains 0.15 kg of air at a temperature of 350°c and a pressure of 2 mpa,...
Questions
question
Mathematics, 01.06.2021 20:10
question
Mathematics, 01.06.2021 20:10