Engineering, 06.07.2019 03:20 demotte79991
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
You know the right answer?
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a...
Questions
Biology, 24.04.2020 00:33
Medicine, 24.04.2020 00:33
Social Studies, 24.04.2020 00:33
Computers and Technology, 24.04.2020 00:33
Mathematics, 24.04.2020 00:33
Health, 24.04.2020 00:33
Mathematics, 24.04.2020 00:33
Biology, 24.04.2020 00:33
Mathematics, 24.04.2020 00:33
Mathematics, 24.04.2020 00:34
Mathematics, 24.04.2020 00:34
Mathematics, 24.04.2020 00:34
