You can use the method to replace an item at a specific location in an arraylist.

4.11 painting a wall (1) prompt the user to input integers for a wall's height and width. calculate and output the wall's area (integer). note that in this case there is a new line after each prompt. (submit for 1 point). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet (2) extend to also calculate and output the amount of paint in gallons needed to paint the wall (floating point). assume a gallon of paint covers 350 square feet. store this value in a variable. output the amount of paint needed using the %f conversion specifier. (submit for 2 points, so 3 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons (3) extend to also calculate and output the number of 1 gallon cans needed to paint the wall. hint: use a math function to round up to the nearest gallon. (submit for 2 points, so 5 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons

Kto rozmawia z clamentain przez krótkofalówke w the walking dead w 4 epizodzie

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.